Installation Guide for Hurricane Hook™

It is very simple to install your VuSafe Panels. Please read through the instructions thoroughly before starting. It is a good idea to install your panels at least once before the onset of the hurricane season so that you are not attempting this for the first time while under threat of an approaching storm. If you have any questions please call 1-888-232-2331.

1. Prepare the locations to be protected:
Install any removable tracks (H header, Stud sills, F-track etc.). Insure proper anchorage to wall structure or floor surfaces. Slide the proper number of track bolts into any F tracks roughly aligning them with the panel spacing.

2. Match the numbered panels to each correspondingly numbered location:
The top and bottom of each panel have 3 keyhole punches. The top holes align with the Hurricane Hooks while the lower ones correspond with the stud bolts of the sill track.

Install the first panel by lowering it over the first group of three Hurricane Hooks and guiding the stud bolts through the bottom holes. Loosely secure the first two attachment keyholes using one washer and one wing nut for each. Leave the third panel hole open to receive the next panel.

Each subsequent panel is installed overlapping the previous at the common flange. Be sure not to tighten any wing nut hardware yet. As you work your way across the opening, jostle panels into vertical alignment.

Some openings will require that the last panel be overlapped by 50% or a half panel may be supplied.

If a center support is specified, (center of panel F track), the center of the panels will also be keyhole punched. Be sure to align the track bolts for this as you install each panel and again, leave these wing nuts loose.

3. Secure the panels:
Starting at one side of the opening tighten down the first set of wing nut & washer. Proceed to the next panel and repeat, tightening the hardware at the first panel overlap. Repeat this procedure until all location panels are secure. Next, tighten any center support F-tracks and related hardware.

  1-888-232-2331

CONTRACTORS

  • STEP ONE:
      Authorized Installer Registration Form
  • STEP TWO:
      Interview with a
      VuSafe Account Manager